Mts DCPD Measurement System Manual de usuario descargar pdf (Pagina 19)

DescriptionLabelItem

Cable connector to controller DIO.Control7

Power switch: I = on, O = off.I/O8

Chassis and earth ground connections.Grounds9

Standard AC power plug.Input Power10

Connector pairs: orange are analog outputs to the

controller; green and yellow and connections to the

Channel n11

preamp. A typical DCPD system supports a single

reference specimen and a single active specimen.

Connects between the DCPD box and the reference

specimen and active specimen(s). One preamp is

required for every two specimens

Preamp12

Status Lights (Front View)

DescriptionLight

When lit, indicates that mains power is switched on, but specimen current is

either switched off or is at a setting below that for normal testing, or the

specimen is not connected.

Red

Indicates that specimen current is being provided to the specimen, but not at

a low current setting.

Green

For more information on the status lights, see the Troubleshooting chapter.

DCPD Measurement System | 19

Introduction

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Sin comentarios

Mts DCPD Measurement System Manual de usuario Pagina 19