Mts Multipurpose Getting Started Manual de usuario

MTS TestSuiteMultipurpose Elite Getting Started Guide100-222-007 F be certain.

DescriptionItemItemThe contents of the Toolbox panel change depending on thenode selected in the Explorer panel:Toolbox panel5• When you select the Pr

2. Click the Power icon to open the Power Panel. Click Low then High for the Hydraulic Power Unit (HPU).Repeat for the Hydraulic Service Manifold (HSM

Run ButtonThe test executes for approximately 20 seconds. While the test runs, a Hysteresis and History graphshows runtime data. When 100 cycles are c

Note:After reviewing the test report, exit Microsoft Excel.Example LCF Test Report1.2.7.0 Run More Tests and Explore the Software (Optional)Perform ad

or• After installation, on your computer in the C:\MTS TestSuite\TestArchives folder.Instructions on how to run these tests are found in the MPE Simul

100-222-007 F

© 2013 MTS Systems Corporation. All rights reserved.Trademark InformationMTS is a registered trademark of MTS Systems Corporation within the United St

Contents1.0 Introduction 51.1.0 Getting Started in Simulation...

1.0 IntroductionTopics:•Getting Started in Simulation...

1.1.0 Getting Started in SimulationThis guide gets you started using MTS TestSuite software by running an example test in simulation mode.This allows

1.2.3.0 Launch the Simulation Software1. Launch the MTS Series 793 Station Manager application:• Double-click the Station Manager icon located on your

• Click Start > Programs > MTS TestSuite > Multipurpose Elite.MPE IconThe application opens and connects to the station configuration.The con

Multipurpose Elite Application Main WindowMain Window OptionsDescriptionItemItemProvides menus and quick-access icons that allow you toperform tasks s