Mts Series 322 Load Frames Manual de usuario descargar pdf (Pagina 57)

Series 322 Load Unit Operation

Load Unit: Position the Crosshead Hydraulically

1. This step pressurizes the lift actuators. The crosshead might have shifted

position while hydraulic pressure was turned off.

Briefly turn the Crosshead Lift/Lock Controls to the lift crosshead

position to apply a slight upward pressure to the crosshead.

Then return the lift control to the stop position.

2. Use the Crosshead Lift/Lock Controls to unclamp the crosshead.

Wait 30 seconds for the pressure in the crosshead locks to drop to zero.

Note Always lower the crosshead to where you want it. The pressure

remaining in the lift cylinders after raising the crosshead can slightly shift

its alignment. Lowering the crosshead to its final position removes this

pressure and improves alignment.

3. Use the Crosshead Lift/Lock Controls to move the crosshead to a point

where you can install the specimen (or specimen fixture) into the upper grip

or fixture without obstruction.

Set the control to the stop position “O” before proceeding.

4. Use the Crosshead Lift/Lock Controls to clamp the crosshead to its current

position.

Wait 30 seconds for the locks to fully clamp the columns.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 95 96

Sin comentarios

Mts Series 322 Load Frames Manual de usuario Pagina 57