Mts SWIFT 50 GLP Sensor Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 70
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
SWIFT 50 GLP Sensors Installation
22
Coordinate System
Hardware Overview
The SWIFT coordinate system is transducer-based, with the origin located at the
center of the transducer. Positive loads are defined as applied to the outer ring of
the transducer.
Vertical force (Fz) is positive up
Lateral force (Fy) is positive out of the vehicle
Longitudinal force (Fx) is positive out of the transducer
You can change to the MTS Model 329 Road Simulator convention (lateral load
into the vehicle is always positive) or to any coordinate system by changing the
polarities in the calibration file. For instructions on how to change the coordinate
system polarities, see “Setting up the Transducer Interface” in the SWIFT 50
GLP Sensor Product Information manual (MTS part number 100-162-722).
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 69 70

Comentarios a estos manuales

Sin comentarios