Mts Multi-Pump Control Manager Remote Human-Machine In Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
Remote Human Machine Interface
20
Status Screen
Operation
Status
Indicator: Indicates the state of the associated module.
Status - blue-green: Label.
Disabled - light gray: Indicates the module is present but is not
enabled.
Enabled - green: Indicates module is enabled and is ready to into a
run condition (replaces READY).
Running - green: Indicates the associated pump module is running
in low pressure.
High pressure - green: Indicates the associated pump module is
running in high pressure.
Overload - red: Indicates an overload condition exists and a
module fault/unit alarm is active for the associated module.
Sequence - yellow: Indicates that the PLC commanded the motor
contactor to close but the contactor did not close after a 10 second
time period and a module fault/unit alarm is active.
Note If the first module to start faults in manual mode, the start
sequence stops.
Hours
Indicator: Indicates the running time in hours of the associated
module.
Hours - blue-green: Label
Value - gray: The number of total hours the associated module has
been running.
Screen select buttons
These pushbutton/indicators are described in the Main Screen
section; refer to “Main Screen” on page 14.
Name and Location Description
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Comentarios a estos manuales

Sin comentarios