Mts Multipurpose Simulated Manual de usuario descargar pdf (Pagina 47)

DescriptionParameter

Specify the wave shape of the command

signal.

FCG Wave Shape

The choices are True Sine or True Ramp.

Typically, you use a True Ramp wave shape

where uniform strain-rate sensitivity is

important, and a True Sine wave shape

where a continually varying strain rate is

acceptable because of the higher frequencies

of some tests.

Specify the load level at which the voltage is

measured. This parameter is used only for

FCG DCPD tests.

FCG Measure Load Level

5.3.2.6.0 Constant Load Control Mode Parameters

Constant Load Control Mode Parameters

DescriptionParameter

Specify the ratio of the minimum to maximum

load applied to the specimen. The minimum

FCG Load Ratio

load is determined by this value and the

maximum load is specified by you.

Specify the desired end level of the command

signal.

FCG End Level 1

Specify the cycle frequency of the command

signal.

FCG Frequency

Specify the wave shape of the command

signal.

FCG Wave Shape

The choices are True Sine or True Ramp.

Typically, you use a True Ramp wave shape

where uniform strain-rate sensitivity is

important, and a True Sine wave shape

where a continually varying strain rate is

acceptable because of the higher frequencies

of some tests.

Specify the voltage that is measured at this

load level. This parameter is used only for

FCG DCPD tests.

FCG Measure Load Level

MTS TestSuite 47

5.0 Running Simulation Tests

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 99 100

Comentarios a estos manuales

Sin comentarios