Mts SWIFT 10 ATV Sensor Manual de usuario descargar pdf (Pagina 90)

SWIFT 10 ATV Sensors

Road Simulator

Installing the Transducer

A. With the transducer and adapter plate assembly against the inner hub

adapter, position the slip ring bracket, with the slip ring, against the

transducer.

Ensure the connectors between the slip ring bracket and the transducer

engage properly.

Note If the jack screws used to remove the slip ring bracket are still in the slip

ring bracket, remove them before continuing.

B. Use the eight M8 fasteners provided to attach the slip ring bracket to

the transducer and inner hub adapter. Hand tighten the bolts.

C. Lubricate the threads and under the head of each fastener with

Molykote g-n paste.

Bolt Torque Sequence

D. Following the inner bolt pattern sequence shown in the previous figure,

torque the eight M8 bolts (A through H) to the value for the first

increment shown in the following table.

E. Repeat Step 6D for the second increment.

Note To minimize negative clamping effects, you must torque the bolts in the

sequence shown in the figure above.

Inner Bolt

Pattern

Outer Bolt

Pattern

S10-12

D B

Jack Screw

Holes

TORQUE INCREMENT M8 BOLT SIZE M10 BOLT SIZE

1st Increment

19 N•m (14 lbf•ft) 26 N•m (19 lbf•ft)

Final Increment

38 N•m (28 lbf•ft) 53 N•m (39 lbf•ft)

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 143 144

Sin comentarios

Mts SWIFT 10 ATV Sensor Manual de usuario Pagina 90