Mts SWIFT 10 MC Sensor Manual de usuario descargar pdf (Pagina 87)

Road Simulator

SWIFT 10 MC Sensors Installing the Transducer

Assembling the Non-Slip Ring/Encoder Side (typical – rear shown)

8. Assemble the slip ring/encoder side as follows (refer to the next figure

during the assembly):

A. If you have not already done so, attach the stock brake disk (if used) to

the inner hub/brake disk adapter using the fasteners provided.

Apply Locktite 262 Threadblocker to the screws and torque to the

manufacturers specifications.

B. Apply a little grease or oil to the outer surface of the axle spacer and

insert it into the inner hub adapter from the oil seal/bearing side. Push

until you feel it snap in place against the bearings.

C. From the opposite side insert the load spacer.

Apply grease to reduce

friction between axle

spacer and oil seal

and bearings

Axle

Spacer

Axle

Spacer

Inner Hub/

Sprocket or

Brake Disk Adapter

Stock Sprocket (rear)

or Brake Disk (front)

Load Spacer

Inner Hub Assembly

Sprocket Side – Rear (shown)

Stock Sprocket

or Brake Disk

Oil Seal

S10MC-12R

Sealed

Bearings (2)

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 143 144

Sin comentarios

Mts SWIFT 10 MC Sensor Manual de usuario Pagina 87