Mts WIFT Mini Transducer Interface Manual de usuario descargar pdf (Pagina 58)

SWIFT

Mini TI

SWIFT Sensor Setup for Data Collection

Installation

5. Install the inclinometer/level bracket assembly on the transducer by

inserting the dowel pins in the level bracket into the pin pilot holes provided

in the transducer, as shown in the next figure.

The orientation of the inclinometer/level bracket assembly is determined by

the orientation of the anti-rotate bracket.

6. Adjust the tire rotation, as necessary, until the inclinometer reads 0.0°, ±0.1°

(or 90.0°, ±0.1°) depending on the orientation of the inclinometer as shown

in the previous figure.

7. Push the Zero button on the front of the TI box.

The Zero indicators will toggle during the zero process. When the Zero

indicators turn off the process is complete for this angle.

8. Remove the level bracket/inclinometer assembly.

Zero Button and

Indicators

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 85 86

Sin comentarios

Mts WIFT Mini Transducer Interface Manual de usuario Pagina 58