Mts SWIFT 40 Sensor Manual de usuario descargar pdf (Pagina 119)

SWIFT 40 Sensors Maintenance

119

Transducer Interface

The electronics for your transducer require a minimum amount of maintenance.

Ensure that they remain in good condition by checking the ventilation and

cleaning the fan filter at regular intervals.

Daily Check the transducer interface cooling daily. A cooling fan is located at the back

of the unit. Do not block, obstruct, or reduce the air flow from the fan. Items

placed in front of the fan will restrict the airflow and cause the electronic

components to overheat. Remove any items (such as boxes or spare parts) that

block the cooling fan.

Monthly Inspect the foam air filter located in the front and back of the transducer interface

monthly, or after very 160 hours of operation. Clean the filter if it is dirty.

Depending on the operating environment, you may need to check and clean the

filter more or less frequently. (For example, if there is a significant amount of

dust present, you will want to check the filter as often as once a week. If the air

quality in your lab is very good, you may only have to check the filter once every

two months.)

Clean the filter by vacuuming it. If you cannot remove the dirt, wash the filter in

warm water with a mild detergent. Check the filter for damage and replace it if

necessary (MTS part number 10-087-561).

To remove the filter:

1. Loosen the screws that hold the fan cover in place.

2. Pull off the fan cover and set it aside.

3. Pull out the foam filter.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 169 170

Sin comentarios

Mts SWIFT 40 Sensor Manual de usuario Pagina 119