Mts SWIFT 20 Ultra Sensor Manual de usuario descargar pdf (Pagina 133)

SWIFT 20 Sensors Troubleshooting

133

The data acquisition scales

are set incorrectly.

Check that the data acquisition scales are set

correctly. The full scale calibration range is

shown on the Calibration Report, with 10 V =

Full Scale (unless you requested custom

calibration output before calibration at MTS).

With the TI turned on and all cables from the

SWIFT transducer to TI connected, use a

handheld DVM to check the output on

individual channels while they are being loaded

to make sure that the output at the TI box and

data acquisition correlate. (Use the BNC

connectors located at the back panel of the TI.)

The transducer was zeroed

with load applied (or a

different load than the

intended tare weight for

non-spinning applications

only).

Rezero the TI, being careful not to touch or load

the transducer during the zeroing procedure.

A zero offset is present in

the data.

See Zero Offset on the previous pages of this

Troubleshooting Guide.

Troubleshooting Guide (part 7 of 14)

Symptom Possible Causes Solution

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 175 176

Sin comentarios

Mts SWIFT 20 Ultra Sensor Manual de usuario Pagina 133