Mts SWIFT 20 Ultra Sensor Manual de usuario descargar pdf (Pagina 66)

SWIFT 20 Sensors

Edit the Calibration File

Setting up the Low-Profile Transducer Interface

Edit the Calibration File

Do not change any other items in the calibration file.

The calibration file contains offset values for all of the bridge outputs.

Changing any of the items other than those listed in the following procedure

will cause your calibration file to be incorrect.

Take care not to change any values except those listed in the following procedure.

If your calibration file is incorrectly changed, reload the original file from the

diskette provided by MTS.

What you need to

know

Before you make the changes to the Calibration file you will need to know how

your system is set up (a spinning or non-spinning configuration) and how you

want you data from each sensor formatted (the Output Polarities)

1. Open the calibration file using a text editor.

CAUTION

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 175 176

Sin comentarios

Mts SWIFT 20 Ultra Sensor Manual de usuario Pagina 66